In addition to the correct operation, daily maintenance work also can prolong the service life of the crusher, enhances the working efficiency of the crushing equipment, in order to make running more comprehensive to understand maintenance knowledge, the following will be fully introduced in this paper cone crusher maintenance knowledge.
1. Bearing area is the most easy to damage the parts, because in the use of larger wear so need regular maintenance, bearing high oil temperature rise, it is necessary to stop the machine immediately to check the reason and to eliminate them.
2. The newly installed tire and liner are prone to loose, so should be checked regularly.
3. Chassis plane should remove dirt and other material to avoid activities bearing when machine can’t broken material can’t move on the chassis, so that a serious accident.
4. Look for loose parts bolt and host after installation if the doors of fastening, such as welcome to tighten.
5. It is mainly used for oil change, fuel oil, antifreeze measures to increase freezing facilities. Organized by department, operation supervision and inspection and supervision.
6. Turn the gear during operation if a rushing sound should immediately stop check, and remove.
7. Should have iron removal unit, prevent iron crushing cavity, if frequent iron, may cause the broken shaft accidents.
8. Always pay attention to and timely on the surface of the friction lubricating jaw crusher work can guarantee the normal operation and prolong the service life of equipment. Add 50-70%, the carrying capacity of oil must be replaced every three months time, oil change, the application of clean gasoline or kerosene carefully cleaning roller bearing. Bracket and the bracket pad contact, into the crusher oil prior to the start.
9. Lubricating oil often want to change, not too dirty, is too dirty to accelerate gear and bowl watts, bushing wear, and even death in axle housing research.
10. Drive belt installation cannot too tight, otherwise it will cause not flexible shaft turn or fracture. Also cannot too loose, otherwise it will cause crusher stuffy car.