In the stone production line, equipment maintenance work is to most of the crusher equipment maintenance work, ready to this part of the work will make the stone production line maintenance work is completed. Crusher this equipment workload is bigger, so should pay attention to the maintenance of equipment, maintenance, and some customers only know the surface, however, the service life of crusher is your usual method of machine maintenance and maintenance time, to you the following simple introduce three important aspects of a brief introduction of crusher equipment maintenance maintenance.
1. The bearing maintenance:
Bearing parts of the crusher is the most easily broken, in the use of wear and tear is bigger so often need maintenance, often go to increase the service life of the bearing.
2. Lubricating ways:
Often pay attention to and in a timely manner to do a good job of the friction surface lubrication, to guarantee the normal operation of jaw crusher and prolong the service life of equipment. Join within the bearing grease for capacity of 50-70%, must be replaced once every three months, when the oil change application of clean gasoline or kerosene carefully cleaning bearing roller track. Bracket, when in contact with knee pad crusher must inject grease before moving.
3. The daily aspects:
In order to ensure the crusher equipment in good technical condition, ready to be put into operation, reduce downtime, improve the utilization rate of crusher pipe, to reduce the crusher wear and prolong the service life of crusher; Do regular maintenance, forced to correctly deal with the relationship between the use of maintenance and repair, are not allowed to use don’t raise or not raise.
There are some common problems, need you to understand, as shown below:
1. Crusher wearing parts (mainly lining board) to replace the inconvenience, waste a lot of manpower and time.
The third level 2. Crusher lining damage speed, affect the service life of the equipment. Can be done by improving the third way of broken.
3. In the face of abnormal working condition lack of ability to adapt, main show is the lack of iron automatic release ability, with its work in the continuous stability.
4. In the crusher grinding and screening system is easy to cause discharge stuck even equipment failure, seriously limits the capacity of the equipment.
5. To improve degree of automation. Such as the superhard material into the cavity, is not found in time. Based on this, before we release the crusher in a formal letter to the corresponding transformation, my research topic is aimed at the practical problems of the new type of cone toothed roll crusher equipment renovation.