Some users in the use of counterattack crusher can appear the phenomenon of deformation of the spindle, what is the cause of this phenomenon? Then we can do for you in detail.
1. Feed particles are too large, the material into the device will direct contact with the equipment of the main shaft, then the material particles are too large, and compared with the number of main shaft impact of many words, can cause deformation of the spindle, so we in the counterattack crusher feed material must be good control of the grain, not too big.
2. The equipment overload time is long, any mechanical in overworked after some adverse effects on the equipment, overload work is bound to increase the spindle work pressure, will aggravate the spindle of wear, slowly cause the deformation of the spindle. So when using counterattack crusher work must let equipment to avoid overload.
3. The equipment of the main shaft are rusty phenomenon didn’t get timely treatment, counterattack crusher shaft rust, equipment at run time there will be some rust and materials are mixed together, processing of finished product fineness of materials will be reduced, and the main shaft, because of the rust strength will reduce, will deformation is very serious, and can lead to equipment operation is not smooth. So we have to follow an inspection equipment of the main shaft of usage, what’s wrong places to immediately repair.
4. The device at run time with metal particles into the interior of the equipment, equipment in operation was accidentally metal particles will happen with the main shaft of collision, lead to the main shaft deformation, we feed on equipment must ensure that no impurities.
Counterattack crusher shaft deformation, the best solution is to replace the spindle. So when using counterattack crusher to pay attention to the maintenance of the spindle.