Mechanical equipment is in use for a long time to the optimization of the process operation, after operation on the sand making machine how to optimization of the process for it to work, let me to give you a detailed introduction of sand making machine equipment operation process optimization.
1. Sand making machine equipment check before driving vortex chamber observe whether door is shut, to prevent the material from the vortex chamber to observe rushed out of the door, produce risk.
2. Check system sand machine impeller direction of rotation, from the mouth direction. Impeller should be counterclockwise rotation, otherwise the motor wiring should be adjusted.
3. Sand making machine and conveyor equipment startup sequence is: the discharging to system sand machine, feeding; Crusher must be started light, can give the material after crusher operating normally. In contrast to the boot order stop order.
4. The material particles in strict accordance with the specified requirements, is greater than the specified material into the crusher is forbidden, otherwise, will cause the impeller imbalance and excessive wear of impeller base to jam impeller passage and center into the feed tube, make the crusher can not work normally, found a large piece of material should be ruled out in time.
5. Discharging device of the sand making machine stop moving, should stop feeding in time, otherwise, will cause the crushing impeller, burning motor.
6. Sand making machine feeding strives to continuously even.
7. Crusher in the process of operation, can not have violent vibration and abnormal noise, otherwise, should stop it for checking.
8. Machine lubrication for dry oil lubrication way, add the amount for 1/2 – two-thirds of the bearing cavity, crusher each work, add right amount of grease.
This step is to optimize system sand machine operation process need to pay attention to matters, if you want to learn more about our sand products, welcome to consult customer service, wholeheartedly at your service!